Go About Americas

How to Start a Car With a Bad Ignition Switch

If you’re unsure how to start a car with a broken ignition switch, there are a few things you can try.

First, connect the battery’s positive terminal to the ignition coil.

Next, connect the starter solenoid to the positive terminal of the battery.

After that, you should be able to start the car by shorting the positive terminal of the solenoid to the positive terminal of the battery.

If all else fails, you can use a jumper cable to jumpstart the car.

This involves connecting the negative and positive terminals of the car’s battery to a power source such as a battery charger or an outside power source.

You should be careful not to touch the wires while you’re running the vehicle, as this could cause an electric shock to the car’s starter motor.

If you have a vehicle that was manufactured before the mid-’90s, the ignition system repair process is much easier.

To make the repairs, you need to remove the plastic covering the inner workings of the car.

Once you’ve removed the cover, you can locate the wires and connectors underneath the steering column.

Usually, the wiring harness connector is in the center of the steering column.

If you’re not familiar with it, prechecking the image of the connector before you start the process will help you identify it easier.

A broken ignition switch can cause several problems. It could result in the car stalling or losing power.

The radio may also stop working. Replacing a broken ignition switch should not be too difficult if you have the necessary hand tools.

However, if you don’t have any mechanical experience, it’s best to call a mechanic.

Otherwise, you risk getting stranded, causing the car to stall in traffic.

Fortunately, replacing the ignition switch is not always necessary.

While replacing the switch is a major repair, some car owners simply don’t want to spend the money on a new ignition switch.

Instead, some choose to bypass the switch altogether.

Although the procedure is complicated and technically complex, it can still be done with just a few tools. And you can avoid the high-cost of a professional’s labor.

If the ignition switch is not working, you may be able to start the car by manually releasing the steering wheel.

This may cause the steering wheel to lock up. Then, you should try jiggling the steering wheel to release it.

Alternatively, you may have a broken steering wheel or column locking mechanism. In this case, a lock smith may be able to disassemble the steering wheel lock.

A bad ignition switch is not good for your car. It can damage the electrical system, which may lead to other problems.

Therefore, you should repair it as soon as possible. If the problem persists, you can call a professional.

In addition to having your car fixed, it is important to keep it regularly maintained so that the problem doesn’t occur again.

Leave a Reply

Your email address will not be published. Required fields are marked *